04-28-2020, 12:22 AM
Hey guys!
So this section in the forum is to be setup as a place we can refer beginner questions to when they are asked without having to re-write the whole thing.
I'm sure it will grow over time, but I would like to put ideas down and request more ideas for some beginner threads.
So far, guides that I would like to write for this section consist of:

So this section in the forum is to be setup as a place we can refer beginner questions to when they are asked without having to re-write the whole thing.
I'm sure it will grow over time, but I would like to put ideas down and request more ideas for some beginner threads.
So far, guides that I would like to write for this section consist of:
- How to Calibrate E-Steps
- How to Calibrate X, Y and Z Steps
- How to Level your bed
- How to replace a nozzle
- How to check if your printer has thermal runaway protection
