|
|
Additional Info About daveefordays |
Sex: |
Male |
daveefordays's Most Liked Post |
Post Subject |
Numbers of Likes |
RE: Creality LD-002R Resin Printer |
1 |
|
Post Message |
Well Lucky me! The printer came!!.
This is a really nice looking machine 
[Image:
]
Unfortunately I'm behind on getting resin, hopefully I will have some by the end of next week 
I'll still show you guys what's in the box, I think my proper review layout will need to wait until next week.
Unboxing:
The box arrived in good condition, was slightly bigger than I expected
[Image:
]
There is a piece of cardboard inside on top, to protect the accessories beneath
[Image:
]
Nice little accessories area
[Image:
]
Here's the top of the printer in the box
[Image:
]
All bubble wrapped
[Image:
]
And with the bubble wrap removed
[Image:
]
Inside of the orange lid the foam is covering what I will call the gantry and housing this Bed piece which was shipped not attached to the printer, it is quite heavy:
[Image:
]
[Image:
]
And here's the final result of what was in the packaging.
[Image:
]
The printer without the bed or the orange lid:
[Image:
]
[Image:
]
The instruction manual seems somewhat detailed, I'll show some select images below. Probably no need to show all the individual steps:
[Image:
]
[Image:
]
[Image:
]
[Image:
]
[Image:
]
Now this last page interests me, it mentions a release film, and there was this package of release film included in the box as well:
[Image:
]
I have much to learn with resin printing as i am basically a novice, I didn't realise there was a release film but it makes sense that the resin will harden directly on the screen and needs a way of coming off of it.
Does anyone have any tips for me for when I get my resin and start using this machine? |
|